Brannstrom specializes in the field of MARPOL equipments for marine pollution control as per MEPC regulations , AL GHWASA TECHNICAL EQUIPMENT TRADING LLC Techno Services are the authorized sales and service agents for brannstrom products and factory authorized service station to perform Accuracy Checks , Upgradations , of Oil Discharge Monitoring Systems as well as 15 ppm Bilge Alarm Units as per IMO regulations. Brannstrom manufacture 15 ppm Bilge Alarm Bilgemon 488 unit for Oily Water Separators, ODME Cleantrack 1000 &Cleantrack 1000B (Biofuel Upgraded) Oil Discharge Monitoring Equipments ,Mastertrack 588 for Bilge discharge monitor and alarm offering extra protection against excessive oil discharge from ships with GPS interface . and Silster 168 Silver ION Steriliser for Drinking / Potable Water Disinfection.
The Oil Discharge Monitoring Equipment (ODME) type CLEANTRACK 1000B is a new Fourth Generation ODME, based on a well proven concept further developed to meet the special demands of the latest trends in shipbuilding. It is type approved to meet the requirements of IMO Resolution MEPC.108(49) as amended by MEPC.240(65), with the addition of acceptance for all Bio-fuel blends as defined in IMO Resolution MEPC.1/Circ.761 Rev.1 which entered into force on 1 September 2011. The type approval has since then been amended with more Bio-fuel blends as per IMO resolution MEPC.2/Circ.21 adopted on 1 December 2015. The new compact CLEANTRACK 1000B enables easy installation in the hazardous cargo area also far away from the nearest non-hazardous area. Installation work is simplified by a reduced demand of cabling, piping, and bulkhead penetrations. The CLEANTRACK 1000B is available in alternative versions with compact built-in pneumatic or ATEX certified electrical pump for hazardous area, or for a variety of bulkhead mounted external pumps. This makes the CLEANTRACK 1000B ideal also for retrofits without hot work. The smart detachable measuring cell is easy to remove and replace with a newly calibrated cell, if this is preferred to having the system accuracy verified on board.
The 15ppm bilge alarm type BILGMON 488 is type approved to meet the requirements of IMO Resolution MEPC.107(49), and with its small dimensions it is ideal also for retrofit on existing separators. The smart detachable measuring cell with wireless communication is easy to remove and replace with a newly calibrated cell, if this is preferred to having the system accuracy checked on board. On special request the BILGMON 488 is also available as a 5ppm version meeting the requirements of Class notation “Clean Design”.
MasterTrack 588® is a bilge discharge monitor and alarm offering extra protection against excessive oil discharge from ships. Water with an oil content of less than 15 ppm is sent overboard. The amount of water pumped overboard together with the time and GPS coordinate is logged every 10 minutes. OBV close/open, alarms and door open/closed is also logged. The total amount of water pumped overboard and the total amount rejected is shown on the main screen (resettable).
The 15 ppm bilge alarm, BilgMon 488®, the over board valve (OBV) and the communication unit, which logs all important data both electronically and on paper (option), are all enclosed in a locked cabinet. MasterTrack 588® is delivered with 3 high security keys to ensure non bypassing of system by unauthorized methods.
The Oil Contamination Alarm type OILCAP 158 measures capacitance between its rod and the walls of the water tank where it is installed. Lower capacitance indicates a higher concentration of oil in the water. The OILCAP 158 has an adjustable alarm limit, and when the capacitance falls under the set value (the oil concentration rises), a relay with opening & closing contacts is activated with a 1 sec delay. When the capacitance again rises above the set value (the oil concentration falls), the relay is deactivated after a delay which is adjustable from 0 to 30 sec in steps of 2 sec. The OILCAP 158 is also equipped with an alarm relay to indicate power failure.